Kit - AirWard Twin Cessna Elevator Trim Tab Control Hardware Replacement

AirWard has developed a Kit for complying with Airworthiness Directive 2016-07-24 and Cessna Multi-engine Mandatory Service Bulletin MEB-27-02.

The Kit applies to the following aircraft (all serial numbers):

310 thru 310R, E310H, E310J, 310J-1, T310P thru T310R;

320 thru 320F, 320-1

335

340, 340A

401 thru 401B

402 thru 402C

411, 411A

414, 414A

421 thru 421C

The Kit consists of the following items:

2 each NAS6203-8D (replacement for NAS464P3-8) - Close Tolerance - 10/32 Thread - .823 Overall Length - Drilled Shank;

2 each NAS6203-9D (many reports of NAS6203-8D is too short for installing Cotter Pin and allowing the bolt to rotate) - Close Tolerance - 10/32 Thread - .866 Overall Length - Drilled Shank;

6 each NAS1149F0332P (AN960-10L) - Flat Washer - #3 - Thin (extra washers if needed for longer bolts);

2 each MS17826-3 - Nut, Castellated - Low Profile - Nylon Insert - 10/32 Thread;

2 each MS24665-132 - Pin, Cotter - 1/6" Diameter - 1/2" Effective Length;

1 each Copy of Airworthiness Directive 2016-07-24;

1 each Copy of Cessna Mult-engine Mandatory Service Bulletin MEB-27-02;

1 each Copy of Letter to FAA from Tony Saxton - Director of Tech Support - The Twin Cessna Flyer - dated April 8, 2016.